DV DUBBING

Note for DV dubbing

If you press [PAUSE F] at step 5, the tape will rewind to the point a few seconds preceding the paused point.

The unit does not send out the output signal to DVC.

For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.

Do not connect more than 1 DVC.

The unit can only accept DVC. Other DV device such as cable/satellite box or D-VHS VCR cannot be recognized.

If no video signal is detected from the DVC during DVC to DVD dubbing, the recording will be paused and “I” will flash on the TV screen. The recording will resume when the unit detects the video signal again.

When the DVC is in camera mode, refer to “Guide to DV and On-Screen Display” on page 46.

You cannot dub from DVC during timer standby mode.

During timer standby of either component, you cannot select L3(DV-IN) even on the component which is not in timer standby.

Date / time and cassette memory data will not be recorded.

Pictures with a copy-guard signal cannot be recorded.

A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire Wire”. It serves as the interface that connects the PC and peripheral device such as “i.LINK” (registered trademark of SONY). It enables digital dubbing between DV devices with little degradation.

48 EN

E7PCAUD_DR420KU_EN.indd 48

2/6/2009 10:55:38 AM

Page 48
Image 48
Toshiba D-R420KU owner manual 48 EN