Toshiba D-VR610KU owner manual Make the connection as illustrated below, With this setup

CONNECTION TO AN EXTERNAL TUNER

This section describes how to connect this unit to an external tuner such as cable/satellite box.

• When you change the connections, all devices should be turned off.	rear of your TV
• Refer to the operation manual accompanying external devices for more information.

1	Disconnect the power cords of the devices from the AC outlet.
	disconnect

2Make the connection as illustrated below.

e.g.)

AUDIO IN

VIDEO IN

rear of your TV

L

R

RF coaxial cable

TV signal

DVD/VCR

RCA audio

ANT. IN

S-VIDEO IN ---AUDIO---OUT

cable

L

L

RCA video cable

S-VIDEO

VIDEO

RF coaxial cable

HDMI OUT

AUDIO OUT

IN

R

R

DVD

DVD/VCR

OUT

OUT

L

R

DIGITAL

AUDIO

S-VIDEO COMPONENT

S-VIDEO IN ---AUDIO---OUT

AUDIO OUT

OUT

VIDEO OUT

L

L

Y

IN ---VIDEO---OUT

/CB

INR

R

PB

IN ---VIDEO---OUT

PR

/CR

or

OUT

IN

rear of this unit

S-video cable

RCA video cable external tuner

RCA audio cable

Supplied cables used in this connection are as follows:

•RCA audio cable (L/R) x 1

•RCA video cable x 1

Please purchase the rest of the necessary cables at your local store.

Note

•Required cables and connecting methods differ depending on the external tuner. For more information, please contact your external tuner provider.

•Instead of using VIDEO OUT jack of this unit, you can also use S-VIDEO OUT jack, COMPONENT VIDEO OUTPUT jack, or HDMI OUT jack (no AUDIO OUT jack connection required) for connecting to your TV.

With this setup:

•You can record any unscrambled channel by selecting the channel on the external tuner. Be sure that the external tuner is turned on.

•Signal from the external tuner can be output only on CVBS output even when the power of the unit is off.

•You cannot record one channel while watching another channel.

3 Plug in the power cords of the devices to the AC outlet.	rear of your TV
	connect
After making the connection as described above, make
4 sure to select the appropriate video input type by	rear of this unit
following the steps in “SETTINGS FOR THE VIDEO INPUT”	HDMI OUT
on page 20.

Disc Introduction Connections Basic Setup Management Recording Playback Editing Function Setup VCR Function

Note to CATV system installer

•This reminder is provided to call the cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

EN 19

Others

E9KGAUD_D-VR610KU_EN.indd 19

2007/12/18 17:09:46