12. OPERATING PROCEDURES
12.1 WEIGHING OPERATION
12.1 WEIGHING OPERATION
NOTE: Weighing operation is available only when the optional scale unit is connected.
Menu: REG., M.DOWN, or REWRAP
Mode: WEIGH
The weigh mode is used to weigh a commodity and to issue the label. The label contains data such as a weight, unit price (price per weight) and total price (calculated as a result of the weighing operation). The following is a basic operation seen at the sales floor of a store or at a back room where different kinds and weights of commodities are repacked. Pressing the [VOID] key subtracts the last entry from the memory.
Example) When PLU #100 and an unit price of $8.00 are set in the speed key #12.
Enter the PLU #.
1
0
0
Press : PLU
Available only when the initial setting #
Press the speed key.
12 |
lb scale
1/4 | 1/2 |
<REG.> MANU. WEIGH
| lb | UNIT/$ | TOTAL $ |
| 1.000 | 8.00 | 8.00 |
Place a commodity on the platter.
(Ex. 1.000 lb.)
MANUAL : | : | AUTO |
| * |
|
The label is issued
TEC STORE
(TEL)
Press when canceling the last sales.
VOID
(Sample label)
NOTES:
1. Pressing a speed key to which no PLU data has been assigned will result in an error.
In this case, press the C key, then press a speed key to which PLU data has been assigned.
2.To change between AUTO and MANUAL, follow the procedure provided in section 12.9.
3.If a unit price exceeding 4 digits is obtained by multiplying by 2 or 4 (when pressing the 1/2 lb key or 1/4 lb key), the unit price will be 0.
4.When the 1/2 lb , 1/4 lb key is pressed, the unit price does change on the display.
5.When the “compulsory tare” is selected, a tare must be subtracted in a weighing operation, otherwise an error message “TARE REQUIRED” will be displayed when the following operation has been done:
① Manual mode: Pressing the PRT/* key.
②Auto mode: Placing a commodity on the platter.
③ Floating vendor mode: Pressing the Vendor key.
When a “TARE REQUIRED” is displayed, refer to Section 12.6 to follow the proper weighing procedure.
12- 2
