How to attach the accessories, „ Belt Clip

How to attach the accessories

㩷

㩷CAUTION!

㩷1. Care should be taken not to drop the printer when securing it to your waist or slinging it over your shoulder.

㩷2. For fixing the printer to your belt, the belt width should be 40 mm or less Use of the other belts may cause the

㩷printer to drop.

㩷

When you use the printer fixing to your belt, secure
the supplied Belt Clip to the printer back.	M-3x8 Screw
	M-3x8 Screw

1. Secure the Belt Clip to the printer back with the two screws.

NOTE:

Only use the supplied screw to secure the Belt Clip.

Use of other screw may damage the printer inside.

Belt Clip

2. Fasten the Belt Clip to your belt.	Belt Clip

Belt

Use the following procedure to fasten an optional shoulder strap (B-EP900-SS-QM-R) to the printer.

1. 㩷Pass either end of the Shoulder Strap through the Strap Slot of the printer, as shown in the figure Strap Slot below.

2. 㩷Pass the end of the Shoulder Strap through the buckle. Slide the buckle to adjust the Shoulder Strap length.

3.㩷Do the same to the other end of the Shoulder Strap.

㩷

Shoulder Strap

Buckle