
㩷
Carry case (Option)
A carry case exclusively for the printer is available as an option.
Put the printer into the Carry Case using the following procedure.
1.Turn off the printer.
2.Put the printer into the Carry Case in the orientation indicated by the illustration on the right.
NOTE:
Before putting the printer into the Carry Case, remove the Belt Clip, if it has been attached.
3.Close the Media Outlet Flap and the Top Flap of the Carry Case.
NOTE:
When issuing the media, please be sure to open the Media Outlet Flap. Failure to do this may cause a paper jam.
4.Pass either end of the Shoulder Strap supplied with the Carry Case through the ring of the Carry Case.
5.Pass the end of the Shoulder Strap through the buckle. Slide the buckle to adjust the Shoulder Strap length.
6.Do the same to the other end of the Shoulder Strap.
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 | Carry Case | |
㩷 | ||
| ||
㩷 |
| |
㩷 |
| |
㩷 |
| |
㩷 | d | |
㩷 |
㩷
㩷
c
Media Outlet Flap
Top Flap
Ring
Shoulder Strap
㩷 | Buckle | |
㩷 | ||
|
25