Toshiba GL-1010 Installing the Software, Overview, Installing the GL-Fax Driver CD Installation

INSTALLING THE SOFTWARE

N O T E :

The ibutton must be installed on the GL-1010 controller and you must have a facsimile board installed to the e-STUDIO copier prior to installing the GL-1010 fax software. This information is provided as an overview only. For additional information refer to the GL-1010 Administrator’s Guide.

Overview

Before you can begin utilizing the Toshiba’s optional Network Fax Feature for the e-STUDIO GL-1010 systemyou must install the software using the e-STUDIO GL-1010 Fax Client CD-ROM provided. You will use the InstallShield client software setup

process.This section describes several ways to add Fax Driver

to user’s workstations. Prior to installing the GL-Fax and Address Book Editor software, the administrator must install specific hardware and configure the fax options. Only authorized users can modify the device.

Installing the GL-Fax Driver

CD Installation

1Insert the e-STUDIO GL-1010 Fax Client CD-ROM into the CD-ROM drive.

2If AutoRun is enabled, the set-up program begins automatically. If not, choose Run from the Start Menu and then locate the Setup.exe file on the CD. Click OK to launch the setup program. The installation wizard leads you through the process of installing the Fax Driver, Address Book and TWAIN driver.

InstallShield Setup window

26 GL-1010 Network Fax Operator’s Guide