Toshiba GMAD00134010 manual Installing a memory module, Adding memory optional

50	Getting Started
	Adding memory (optional)

Installing a memory module

Memory modules can be installed in the memory module slots on the base of the computer. You will need a small Phillips screwdriver for this procedure.

If the computer has been running recently, the memory module may be hot. The surrounding area may also be hot. Allow the module to cool to room temperature before replacing it. Avoid touching the cover, the module, and the surrounding area before they have cooled. Failure to follow these directions could result in minor bodily injury.

To avoid damaging the computer’s screws, use a small Phillips screwdriver that is in good condition.

Installing a memory module with the computer’s power on may damage the computer, the module, or both.

The computer has two memory slots—Slot A and Slot B. You can install one or two memory modules.

Before you install or remove a memory module, turn off the computer using the Start menu. If you install or remove a memory module while the computer is in Standby or Hibernation mode, data will be lost.

NOTE	For this model, Slot A is the bottom slot. Slot B is the top slot. If only
	one memory module is to be installed, it must be installed in slot A.

If the computer is on, begin at step 1; otherwise, skip to step 3.

1Click Start, and then Turn off computer or Shut Down (depending on the system).

The Turn off computer or Shut Down window appears.

2Click Turn Off or Shut Down.

The operating system turns off the computer.

3Unplug and remove any cables connected to the computer, including the AC adaptor.