Optional Devices

Do not bend the keyboard ribbon cable.

13.Insert the tabs on the front of the keyboard into the corresponding notches on the computer and lower the keyboard into place after ensuring the two release latches click into place.

When seating the keyboard, be sure to connect the circuit board if the keyboard ribbon cable was pulled out while you were removing the keyboard.

14. Screw the two screws and secure the keyboard.

Be sure to use all two screws removed in step 7. Make sure no screw was dropped into the computer. Make sure no foreign matter can be found.

15.Set the keyboard brace into its groove and press down to secure the latches.

16.Install the battery pack. Refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, for details.

17.Turn your computer over.

18.Turn the computer on and make sure the added memory is recognized - to confirmed it, Start -> Control Panel -> System and Maintenance -> System icon.

Removing memory module

To remove the memory module, make sure the computer is in boot mode then:

1.Set the computer to boot mode and turn the computer’s power off. Make sure the Power indicator is off.

2.Remove AC adaptor and all cables connected to the computer.

3.Turn the computer upside down and remove the battery pack. Refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, for details.

Always make sure the display panel is closed in Laptop mode before turning the computer upside down.

4.Follow steps 4 through 9 in Installing memory module to remove the memory module cover.

5.Push the latches to the outside to release the memory module. A spring will force one end of the memory module up.

User’s Manual

8-13