Toshiba MK1032GAX manual 91

WORD 93: Hardware configuration test results

bit 15	0	(Fixed)
bit 14	1	(Fixed)
bit 13	1=device detected CBLID- above VIH
bit12-8	0=device detected CBLID- below VIL
	Device 1 hardware reset result. Device 0 shall clear these bits to zero.
	Device 1 shall set these bits as follows :
		12	Reserved.
		11	0=Device 1 did not assert PDIAG-.
			1=Device 1 asserted PDIAG-.
		10-9 These bits indicate how Device 1 determined the device number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signal was used.
			11=some other method was used or the method is unknown.
		8	1	(Fixed)
bit 7-0	Device 0 hardware reset result. Device 1 shall clear these bit to zero.
	Device 0 shall set these bills as follows:
		7	Reserved.
		6	0=Device 0 does not respond when Device 1 is selected.
			1=Device 0 responds when Device 1 is selected.
		5	0=Device 0 did not detect the assertion of DASP-.
			1=Device 0 detected the assertion of DASP-.
		4	0=Device 0 did not detect the assertion of PDIAG-.
			1=Device 0 detected the assertion of PDIAG-.
		3	0=Device 0 failed diagnostics.
			1=Device 0 passed diagnostics.
		2-1	These bits indicate how Device 0 determined the device number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signa was used.
			11=some other method was used or the method is unknown.
		0	1	(Fixed)

WORD 94: Current automatic acoustic management value

bit 15-8 Vendor’s recommended acoustic management value

bit 7-0 Current automatic acoustic management value

This function is not supported. The value for this WORD is 0000h.

WORD 95-99: Reserved

WORD 100-103: Maximum User LBA for 48-bit Address feature set The value for this WORD is XXXXh.

WORD 104-126: Reserved

WORD 127: Removable Media Status Notification feature set supported This function is not supported. The value for this WORD is 0000h.

Toshiba Corporation Digital Media Network Company

Page 91 of 159

© 2004, Copyright TOSHIBA Corporation All Rights Reserved