Installation space

Reserve space required to install the indoor unit and for service work.

Keep 100mm or more for clearance between top plate of the indoor unit and the ceiling surface.

Installation diagram of Indoor and outdoor units

Before installing the wireless remote controller

With the remote controller cover open, load the batteries supplied correctly, observeing their polarity.

2Wireless remote controller Cover

3 Batteries

or170mm more

Hook

100 mm or more

Hook

1Installation plate

or170mm more

Shield pipe

For the rear left and left piping

Wall

Insert the cushion between the indoor unit and wall, and tilt the indoor unit for better operation.

Do not allow the drain hose to get slack

 

 

Air

 

 

filter

(Attach

 

 

to

 

 

the

front

panel)

 

 

 

6Pan head wood screw

2 Wireless remote controller

4 Remote control holder

When installing the Flow Selector Unit (FS Unit), keep a space more than 300mm for wiring work.

Cut the piping hole sloped slightly

Make sure to run the drain hose sloped downward.

The auxiliary piping can be connected the left, rear left, rear right, right, bottom right or bottom left.

Right

 

 

Rear right

Rear left

Left

Bottom right

Bottom left

 

 

Installation place

A place which provides the spaces around the indoor unit as shown in the above diagram.

A place where there is no obstacle near the air inlet and outlet.

A place that allows easy installation of the piping to the outdoor unit.

A place which allows the front panel to be opened.

CAUTION

Direct sunlight to the indoor unit’ s wireless receiver should be avoided.

The microprocessor in the indoor unit should not be too close to RF noise sources. (For details, see the owner’ s manual.)

4

Page 7
Image 7
Toshiba MMK-AP0072H, MMK-AP0122H Installation space, Installation diagram of Indoor and outdoor units, Installation place