Toshiba P30 manual Installing the Wireless LAN Unit

4 Replacement Procedures

Installing the Wireless LAN Unit

To install the wireless LAN unit, follow the steps below and refer to the figures in the preceding section.

1.Turn the computer upside down and loosen the three embedded M2.5x6 screws securing the wireless LAN compartment cover.

2.Lift off the wireless LAN compartment cover.

3.Fit the wireless LAN unit’s connector to the computer’s connectors and press carefully to ensure firm contact.

CAUTION: Do not touch the connectors on the wireless LAN unit or on the computer. Debris on the connectors may cause malfunction.

4.Gently, push the wireless LAN unit down until the latches engage the unit to hold it in place.

5.Attach the ends of the wireless LAN antenna. The black antenna cable should be attached to the connector near the rear side of the computer, the white antenna cable to the connector closer to the front panel.

6.Use the screw M2.5x6 to secure the Mini PCI bracket.

Note: If your wireless LAN unit is an ‘A’ type card, then the screw will be a safety screw.

7.Seat the wireless LAN compartment cover and secure it with the embedded security screw.

4-16 Satellite P30 Series Maintenance Manual