Toshiba P600DL service manual Function of Power Panel, Power Switch and Power Indicator, On/Off

FUNCTION OF POWER PANEL

REAR OF CABINET

O N

(1)

POWER

OFF

INSIDE OF CABINET

AC INLET

15A 125V/250V AC

AC OUTLET AC100V-240V 50/60Hz

UNSWITCHED MAX 10A

(2)

(3)

No.	Name	Function	Remark
1	Power Switch	Turn ON and OFF main power	ON/OFF
2	AC Inlet	AC 100-240V, 50/60Hz input	3P plug
3	AC Outlet	AC outlet, un-switched, max 10A	3P socket

Note 1: The AC outlet supplies un-switched power source to a second unit in a multi-projection system. Do not use it for any other purpose. Serial connection using this power outlet must be maximum four units including the 1st unit.

Note 2: The plug type of the projection unit power cable may not match the AC outlet. When power is to be supplied to another unit from this AC outlet, please purchase necessary power cable.

Note 3: About Power Supply cord

The Power Supply cord must be in accordance with the applicable standards. A three-core cord, one for ground, must be used.

The power cord must be at least 1.0mm2 and H05VV-F.

POWER SWITCH AND POWER INDICATOR

AC power source is turned-on/off with the Power Switch. When the Power Switch is turned-on, the Power Indicator lights in green color and a projection unit enters active state.

It takes about 30 seconds typically till an image is shown after Power Switch is turned-on.

In the active state, it is possible to power on/off with an external controller. When power is turned-off with an external controller, the Power Indicator lights in red color and a projection unit enters standby state.

Interval from turn-off to turn-on shall be more than 30 seconds. If the interval is not enough, the lamp may not strike. If the user continues to do this, it may shorten the life of the lamp.

The power indicator indicates also failure information of the projection unit.

The later page at appendix list shows the lamp status.

11