Chapter 4 Replacement Procedures
4 2
4.1 Overview
This chapter describes the procedure for removing and replacing the field replaceable units
(FRUs) in the PC. It may not be necessary to remove all the FRUs in order to replace one.
The chart below provides a guide as to which other FRUs must be removed before a
particular FRU can be removed. The numbers in the chart indicate the relevant section
numbers in this manual.
In all cases when removing an FRU, the battery pack must also be removed. When repairing
an FRU that is the potential cause of a com puter fault, use the chart to determine the order in
which FRUs need to be removed.
The tilt stand, if it is installed, can be removed without any other FRUs removed.
4.2 Battery Pack
4.3 HDD
4.4 Memory Module
4.5 Keyboard
4.9 TOP Cover Assembly
4.10 Touch Pad
4.17
Speaker
Box
4.6
Wireless
LAN Card
and BT
module 4.7 3G module card 4.8 Display Assembly
4.11 I/O Boards 4.14 LCD unit
4.12 System Board 4.15 WEB Camera module
4.13 CPU Heat Sink
4.16 Application for Thermal grease
on CPU and North Bridge
Chart Notation
The chart shows the case for the
following example:
Removing a LCD unit
All FRUs down to the “4.2 Battery
p
ac
k
”to”4.5 Keyboard” and “4.9 Top
Cover Assembly” and “4.8 Display
Assembly” above LCD unit must be
removed.
Satellite T130D, Satellite Pro T130D , and PORTEGE T130D Maintenance Manual (960-Q08)