NAMES AND FUNCTIONS OF INDICATORS ON REMOTE CONTROLLER
Display
All indicators, except for the clock time indicator, are displayed by pressing the 
button.
aTransmission mark
This transmission mark ( | ) indicates when the remote controller transmits signals to the indoor unit. |
| |||||||
b Mode indicator |
|
|
|
|
| c | ad b hj |
| |
Indicates the current operation mode. |
|
|
|
|
| ||||
|
|
|
|
|
|
| |||
• Heat pump models |
|
|
|
|
|
|
|
| |
(AUTO: Automatic control, A: Auto changeover control, | : COOL, | : DRY, |
|
|
|
| |||
: HEAT) |
|
|
|
|
|
|
|
| |
c Temperature indicator |
|
|
|
|
|
|
|
| |
Indicates the temperature setting (17°C to 30°C). |
|
|
|
|
|
| |||
d PURE indicator |
|
|
|
|
|
|
|
| |
Shows that the electrical air purifying operation is in progress. |
|
|
|
|
| ||||
e FAN speed indicator |
|
|
|
|
|
|
|
| |
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW | , |
|
|
| |||||
LOW+ | , MED | , MED+ | , HIGH | ) can be shown. | i g | e | f | ||
Indicates AUTO when the operating mode is either AUTO or | : DRY. |
|
| • In the illustration, all indicators are shown | |||||
f TIMER and clock time indicator |
|
|
|
| |||||
|
|
|
| for purposes of explanation. During | |||||
The time setting for timer operation or the clock time is indicated. |
|
| operation, only the relevant indicators are | ||||||
The current time is always indicated except during TIMER operation. |
|
| |||||||
|
| shown on the remote controller. | |||||||
|
|
|
|
|
|
| |||
gHi POWER indicator
Indicates when Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop operation.
h 
(MEMORY) indicator
Flashes for 3 seconds when the MEMO button is pressed during operation.
The 
mark is shown when holding down the button for 3 seconds or more while the mark is flashing.
Press another button to turn off the mark.
iSLEEP MODE indicator
Indicates when the SLEEP MODE is activated.
Press the SLEEP MODE button to start and press it again to stop operation.
jA. B change indicator remote controller
•When the remote controller switching function is set, “B” appears in the remote controller display. (When the remote controller setting is “A”, there is no indication at this position.)
Remote controller switching function
•If two indoor units are installed in the same room or adjoining rooms, both units may start and stop at the same time when the remote controller is operated. This can be prevented by setting the switching function so that each indoor unit is operated only by the corresponding remote controller.
•To use the remote controller switching function, contact the air conditioner dealer or the installation company.
EN | 6 |
