Toshiba RAV-SM1100UT-E HOW to Adjust AIR Direction, Slide Switch, HOW to Insert the Batteries

HOW TO ADJUST AIR DIRECTION

•Never move the flap (Air direction up/down adjusting plate) which is operated on the remote controller with hands except a case of cleaning of the flap.

•While the unit stops, the flap (Air direction up/down adjusting plate) directs downward auto- matically.

•During preparation of heating, the flap (Air direction up/down adjusting plate) directs upward. The swinging operation starts after heating preparation status has been cleared. However, swinging is displayed on the AUTO flap display of the remote controller even if the heating operation is being prepared.

SLIDE SWITCH

•Do not change setting of the slide switch because a malfunction occurs by other settings.

•Before usage, check the slide switch is set to the position as follows;

S K NA H C

53

How to set up the air direction

Every pushing button during operation, the air direction changes.

How to start swinging

When pushing button, set the direction of the flap (Air direction up/down adjusting plate) to the lowest position, and then push button again, the swinging is displayed and the air direction automatically changes upward/downward.

How to stop swinging

Pushing button once again during swinging of the flap stops the flap at the desired position.

Then, when pushing button, the air direction can be set to position from the uppermost position.

•In cooling or dry operation, the flap does not stop when the flap directs downward. If doing so, the flap stops at the 3rd position from the uppermost position.

In heating operation

Removal of battery cover

	Corresponding model
	for change of flap
Slide switch position
		S K N
Flashing position	HIGH
on remote controller	MED.		Swing

Operation mode display of remote controller

Slide switch position

A H C

Direct the flap (Air direction up/down adjusting plate) down- ward, otherwise the hot air may not reach at the foot.

Initial setup

In cooling/dry operation
Direct the flap (Air direction up/down adjusting plate) upward,
otherwise dewdrops may adhere or drip down to near of the
discharge grille.		Initial setup
In air	In all
blowing operation	operation modes
		Series of
Initial setup		operation
Display when swinging stopped
	Fan/Heat operation	Cool/Dry operation

HOW TO INSERT THE BATTERIES

1.Holding the both sides of the cover and remove it by sliding downward.

2.Correctly insert 2 AAA alkali batteries matching + and - polarities with indications.

3.Push RESET button with something tipped and attach the cover.

•Replace the batteries when the display section of the remote controller is difficult to be read, or when the signal cannot be sent if you are not close to the sensor.

(The standard replacement time of the alkali batteries is approx. one year.)

•Use the same type of new batteries for replacing two batteries.

•In case when you do not the remote controller for a long time, remove the batteries.

RESET button

Cover