PDS Setup options screen | Toshiba S20LP instruction

6 F 3 B 0 3 5 6

If the T-PDS is connected to the T2N/T3H on the second layer through the bridge station (T3H only), set the T-PDS's connection method as follow.

STN #1

T2N S20 -LP

T-PDS

S20LP

STN #2			STN #1			STN #3

T3H		S20		S20			T3H	S20
		-LP		-LP				-LP

			S20LP
STN #2		STN #3
T2N	S20	T2N	S20
	-LP		-LP

<T-PDS Setup options screen>

(Note 1) The Layer 1 Station No. specifies the bridge station and the Layer 2 Station No. specifies the target station on the second layer.

(Note 2) Only T3H is available for the bridge station.

(Note 3) The Parity is fixed as even.

⎯ 65 ⎯

Image 66

Toshiba S20LP instruction manual PDS Setup options screen

Contents

T2N/T3H stations Important Information Preface Contents System configuration Introduction to S20LP Station hardware ∙ OverviewT2N include of S20LP Port SN325 SN325 ∙ Status LEDs S20LP port for T2N PU245NFor SN325 ∙ Reset switch only SN325 ∙ Station number setting switches∙ Transmission cable connectors ∙ Loader port LS overview Menu ⎯ 10 ⎯ Specifications S20LP system specificationsS20LP-station specifications Scan transmission overview Setting the data send block by S-LS Allocation and network assignment by T-PDS Setting for data linkage Station number settingSettings on T-PDS Link PDS screen example Block Send Receive ⎯ 18 ⎯ Global ⎯ 20 ⎯ Settings on S-LS ⎯ 22 ⎯ ⎯ 23 ⎯ ⎯ 24 ⎯ ∙ Scan Transmission ∙ Scan Access∙ Start with Standby mode ∙ Message Transmission ∙ Target Scan Time Data linkage example ∙ Settings on T-PDS Setting on S-LS LS setting screen 2 for STN #2 Cable connections ∙ Station down RAS functionBehavior in trouble ∙ Transmission cable breakage Self-diagnostic function At initialization at power onDuring operation LED indication SN325T2N RAS information monitored in T2N/T3H Station status Online map Standby map Loop map Only T2N RAS information monitored on S-LS Number 1-64 on the screen shows the Station number Self Station Station No.01 Offline Select the Station Number Click the Status Display Possible error message are as follows Station down information Instruction format Instruction SpecificationExpanded data transfer instruction Function Parameter and construction Transfer parameter table Sample program ∙ Operation Remarks Computer link protocol Message transmissionMessage transmission PC link protocol ∙ Send Transfer parameters a CMD Status B TermSTS Status Meaning Detailed Information Send completion status PC link protocol transmission Data write Transfer parameters RID Status See 7.3 5 for details on bits C, D, E, and F Important items XW/YW PC link protocol transmission Data read ⎯ 57 ⎯ SW067 Write enabled PC link protocol transmission program Remarks Length END Appendix Scan cycle ⎯ 63 ⎯ PDS remote programming PDS Setup options screen