Global | Toshiba S20LP manual

6 F 3 B 0 3 5 6

c)If two S20LP-stations are mounted on the T3H and multi layers Scan transmission function is used, use the "GLOBAL" setting. (GLOBAL is invalid for T2N)

<Setting example 3>

CH1	CH1		CH2	CH2
Network	S20LP-station	T3H	S20LP-station	Network
assignment	common memory	W registers	common memory	assignment

			LINK
		Block 1	Send 1
	Receive		LINK
		Block 2
LINK
		Block 3
LINK
	Send 1	Block 4
LINK			Receive
		Block 5
LINK
		Block 6
GLOBAL
		Block 7
GLOBAL	Send 2
		Block 8
			GLOBAL
		Block 9	Send 2
			GLOBAL
		Block 10
	Receive	.
		.
		.	Receive
		.	Receive
		.
		.
			LINK
		Block 32
		⎯ 19 ⎯

Image 20

Toshiba S20LP instruction manual Global

Contents

T2N/T3H stations Important Information Preface Contents System configuration Introduction to S20LP T2N include of S20LP Port Station hardware∙ Overview SN325 SN325 For SN325 ∙ Status LEDsS20LP port for T2N PU245N ∙ Station number setting switches ∙ Transmission cable connectors∙ Reset switch only SN325 ∙ Loader port LS overview Menu ⎯ 10 ⎯ S20LP-station specifications SpecificationsS20LP system specifications Scan transmission overview Setting the data send block by S-LS Allocation and network assignment by T-PDS Settings on T-PDS Setting for data linkageStation number setting Link PDS screen example Block Send Receive ⎯ 18 ⎯ Global ⎯ 20 ⎯ Settings on S-LS ⎯ 22 ⎯ ⎯ 23 ⎯ ⎯ 24 ⎯ ∙ Scan Access ∙ Start with Standby mode∙ Scan Transmission ∙ Message Transmission ∙ Target Scan Time Data linkage example ∙ Settings on T-PDS Setting on S-LS LS setting screen 2 for STN #2 Cable connections RAS function Behavior in trouble∙ Station down ∙ Transmission cable breakage During operation Self-diagnostic functionAt initialization at power on T2N LED indicationSN325 RAS information monitored in T2N/T3H Station status Online map Standby map Loop map Only T2N RAS information monitored on S-LS Number 1-64 on the screen shows the Station number Self Station Station No.01 Offline Select the Station Number Click the Status Display Possible error message are as follows Station down information Instruction Specification Expanded data transfer instructionInstruction format Function Parameter and construction Transfer parameter table Sample program ∙ Operation Remarks Message transmission Message transmissionComputer link protocol PC link protocol ∙ Send Transfer parameters a CMD Status B TermSTS Status Meaning Detailed Information Send completion status PC link protocol transmission Data write Transfer parameters RID Status See 7.3 5 for details on bits C, D, E, and F Important items XW/YW PC link protocol transmission Data read ⎯ 57 ⎯ SW067 Write enabled PC link protocol transmission program Remarks Length END Appendix Scan cycle ⎯ 63 ⎯ PDS remote programming PDS Setup options screen