Turning the power off | CONTENTS | 31 |
Control panel
Remote control |
|
| |
| (Main unit side) | ||
| 1,2 | AUTO | AUTO |
INPUTON/STANDBY | KEYSTONE | SET | |
LASER |
|
| |
|
|
| |
1 |
|
| Press ON/STANDBY after using the projector. |
|
|
| |
|
|
| An instruction message appears. |
|
|
|
|
|
|
|
|
2 |
| Press ON/STANDBY again. |
|
| |
|
| Cooling starts. Once cooling is completed, the LAMP and FAN |
|
| indicators turn off and the standby mode is set. (The ON |
|
| |
|
| indicator turns in orange.) |
KEYSTONE | AUTO | SET | VOL/ADJ. |
|
LAMP ON
(Green) 
(Orange)
Flashing FAN
LAMP ON
(Off) (Orange)
FAN
LAMP ON
(Off) (Orange)
FAN
| ||
VOLUME/ADJUST | EXIT | |
| ENTER | |
A
(Green)
B
(Green)
C
(Off)
Operations
|
| MENU | INPUT |
|
MENU | ENTER EXIT |
| ON/STANDBY | 1,2 |
PIP | FREEZE |
|
| |
|
|
|
| |
CALL | RESIZE |
|
|
|
MUTE | TEMP LAMP ON | 2 | ||
|
| |||
|
| BUSY | FAN | |
|
|
|
| |
Indicators
ATo protect the light source lamp, the LAMP indicator blinks as long as a minimum of cooling is necessary. The power cannot be turned back on during this time. Unplugging the power cord at this time will shorten the lamp’s duration life.
BThe cooling fan continues to run for a while to expel the heat remaining inside. If you are in a hurry, however, you may unplug the power cord at this time.
CThe standby mode is set.
Notes
•The projector consumes about 20W of power in the standby mode. We recommend you to unplug the power cord when not using the projector for long periods of time.
•Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the power by unplugging the power cord while the projector is operating or the light source lamp is being cooled will shorten the lamp’s duration life.
