Turning the power off | CONTENTS | 33 |
Remote control
INPUT |
| ON/STANDBY | 1,2 |
| LASER |
|
|
KEYSTONE | AUTO | SET |
|
|
|
1
2
ON/STANDBY
ON/STANDBY
ON/STANDBY
ON/STANDBY
Press ON/STANDBY after using the projector.
An instruction message for turning the power off appears on the screen and disappears after a while. When the message disappears, operation becomes invalid.
Press ON/STANDBY again.
Cooling starts. Once cooling is completed, the LAMP and FAN indicators turn off and the standby mode is set. (The ON indicator turns in orange.)
VOLUME/ADJUST
MENU ENTER EXIT
ON | LAMP | |
(Green) | ||
| ||
(Orange) Flashing | ||
| FAN | |
A (Green)
LAMP
ON
(Off) (Orange)
B
FAN
(Green)
LAMP
ON
(Off) (Orange)
C
FAN
(Off)
Operations
PIP FREEZE
RESIZE
CALL MUTE
Control panel
(Main unit side)
2
A | To protect the light source lamp, the LAMP indicator blinks as long as |
| a minimum of cooling is necessary. The power cannot be turned back |
| |
| on during this time. Unplugging the power cord at this time will shorten |
| the lamp’s duration life. |
| The cooling fan continues to run for a while to expel the heat remaining |
B | |
| inside. If you are in a hurry, however, you may unplug the power cord |
| at this time. |
| The standby mode is set. |
1,2 |
|
|
| ON |
|
|
|
| |
|
|
|
| R |
|
|
| TE | |
|
|
| EN |
|
|
|
| U |
|
|
|
| N |
|
|
|
| E |
|
|
|
| M |
|
| P | U | T |
|
IN |
|
| ||
|
|
| ||
|
|
|
| |
LAMP
ON / STANDBY
TEMP
VOL / ADJ
Indicators
FAN
EXIT
A |
|
UT |
|
O | S |
| ET |
K
E
Y
S
T
O
N
E
C |
Notes
•The projector consumes about 20W of power in the standby mode. We recommend you unplug the power cord when not using the projector for long periods of time.
•Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the power by unplugging the power cord while the projector is operating or the light source lamp is being cooled will shorten the lamp’s duration life. Should a fault or some other irregularity arise with this unit, unplug the power cord.
•When reinserting the power plug before the lamp has cooled, please wait until the lamp has cooled sufficiently before use. When the lamp is at a high temperature, it may not light and it’s life duration will be shortened.
