Locking the white balance
CONTENTS | 60 |
Camera control panel
W.BALANCE OVERLAY | ARM LIGHT |
LOCK |
|
CAMERA | CAMERA |
GAIN |
|
2
This projector ’s camera is always being adjusted automatically for projected color balance;
however, the balance can shift away from optimum due to the color scheme of the document. Should this occur, the white balance can be set to a fixed condition by using the following procedure.
1 | Project a white paper and enlarge it to fill the |
screen. |
2 LOCK | W.BALANCE Press W.BALANCE to turn the LOCK indicator |
on. |
The white balance is locked.
To release the white balance, press W.BALANCE again to turn the LOCK indicator off.
Notes
•If you raise up the arm while the camera input is being selected, the color of the picture may vary for an instant due to the automatic white balance adjustment. This is not a malfunction.
•If you put the arm back and raise it again while the white balance is locked (the LOCK indicator is lit), the projector will release the white balance.
•Depending on the tint of the indoor illumination, the white balance might not be compensated optimally. Should this be the case, or if you would like to adjust it to a desired tint, adjust
