Toshiba TLP780E owner manual Controlling the projector by using RS-232C, Command list

Controlling the projector by using RS-232C

You can also control the projector by entering the command from a computer via RS-232C.

CONTENTS 73

Signal assignment of RS-232C						Interface format
1 2					1	Communication
		Pin No.	Signal	Description
						method
4
		1	RXD	Receiving data
3	5	2	CTS	Consent to send	2	Communication
		3	DSR	Data set ready
						format
6	8	4	GND	Signal ground
		5	RTS	Request to send	3	Data format
7		6	N.C	No connection
CONTROL RS-232C		7	TXD	Sending data
		8	N.C	No connection	4	Return value

RS-232C

9600 bps, No parity, Data length: 8 bits,

Stop bit: 1 bit

STX (02h) Command (3Byte) ETX (03h)

One command only can be used per communication.

Commands shall be composed of alphanumeric characters of ASCII description. Use only capital letters.

Acknowledge ACK (06h)

Not Acknowledge NAK (15h)

Command list

Classification	Items/Status		Selection	Adjustment	Analog RGB(1)	Digital RGB	Video	Y/PB/PR	Camera
			Command	Command	Analog RGB(2)		S-Video
Power	On		PON	-	Yes	Yes	Yes	Yes	Yes
	Off (with confirmation message)		POF	-	Yes	Yes	Yes	Yes	Yes
	Shut Down (without confirmation message)		PSD	-	Yes	Yes	Yes	Yes	Yes
Normal (RS	-232C Condition Display Off)		DOF	-	Yes	Yes	Yes	Yes	Yes
Picture	Contrast		VCN	Yes	Yes	Yes	Yes	Yes	Yes
	Brightness		VBR	Yes	Yes	Yes	Yes	Yes	Yes
	Sharpness		VSH	Yes	-	-	Yes	Yes	Yes
	Camera gain	Increase	CGU	-	-	-	-	-	Yes
		Decrease	CGD	-	-	-	-	-	Yes
	Picture mode	Bright	MVB	-	Yes	Yes	-	-	-
		True color	MVP	-	Yes	Yes	-	-	-

Notes

•When commands are transmitted serially, wait for the reply of the projector (acknowledge or not acknowledge) before sending the next command.

•Adjustment commands include “ARG” (increase adjustment value) and “ALF” (decrease adjustment value). For usable items (marked "Yes"), send after the selection command.

•The "Yes" marks in the input source columns indicate that that command can be used.

Others

Continued