Toshiba TLP780E owner manual Connecting a computer Computer in 2 connector

Connecting a computer (COMPUTER IN 2 connector)

CONTENTS 23

You can project the picture of analog RGB or digital RGB signal from a computer by using the COMPUTER IN 2 connector. Check that the power supplies for the projector and for the computer are off before connecting the cables.

				COMPUTER IN 2 connector (DVI connector)
				For use as both analog RGB (2) input and digital RGB input. At shipping
				from factory, it set for use as Analog RGB (2) input. Change the setting on
				the menu screen when using as Digital RGB input. 45
USB	MONITOR COMPUTER IN 1		COMPUTER IN 2
	OUT ( Y/PB/PR )
	CONTROL
				AUDIO IN jack
	IN	R - AUDIO - L	VIDEO S-VIDEO	For use as both audio signals for RGB input (analog RGB (1)/analog RGB
	AUDIO		VIDEO IN
				(2)/digital RGB) and Y/PB/PR input.
				Connecting a Mac adapter for
				Macintosh computers (supplied)
				Computer
			To COMPUTER IN 2 connector
			Be sure to connect in the proper
			direction.
				To monitor port
				DVI cable (supplied)
	To AUDIO IN jack			ø3.5mm Stereo mini-jack
		Audio cable (supplied)		To audio output port

Notes (Please also read “Notes” on page 22.)

•DVI digital cable needs to be purchased separately when you input a digital RGB signal.

•Although infrequent, noise might be generated on the screen depending on the types of computer and connection cables. Should this occur, reduce the refresh rate of the computer signal, or lower the resolution. Use of connection cables that are 2 m or shorter is recommended.

•The input signal specifications of the DVI port of the projector conform to DVI 1.0 specifications; however, contents protection is not supported. Note that there is no guarantee for the operations not specified in this specification.

connectionsInstallation and