Sanyo CHDZR14053, XMHX1252, XMHX1852, CHDZR09053 Important Note When Wiring for Common Type

Clamping clip

5-4. Important Note When Wiring for Common Type

Connect the wires referring to the diagram. Note that the remote control wires and the power supply wires are not supplied. The remote control wires shall be segregated from the power supply wires as follows:

1.Install the optional remote control wires (field supplied) and the manufacturer supplied 3-way wiring harness to the electrical connection box as shown in the diagram. One end of the optional remote control wiring is connected to the R1/R2 terminals.

2.Connect the power supply wires to "L1, L2" of the terminal block. Be sure to connect the grounding conductor of the incoming power supply to the earth (ground) screw.

3.Securely affix the power supply wires and remote control wires by the clamping strap or clamping clip not to cross each other and not to leave the wirings loose. When loosening the clamping clip, twist the strap and it will come undone.

Twist

NOTE

X Type
Earth screw
Power wiring
(field supplied)
	3-way connection
Clamping	wiring with harness
	(supplied)
clip
Conduit	Optional remote control
	wire (field supplied)

Securely affix the 3-way wiring harness with the remote control wire (X type).

A Type		U Type
	Optional remote control	Conduit
	wire (field supplied)
		Earth screw
		Power wiring
		(field supplied)
		Conduit
		Clamping
Clamping		clip
		Power wiring
clip	Earth screw	(field supplied)
		Optional remote control	3-way connection wiring with
		wire (field supplied)	harness (supplied)
		73
W-3WAY_ECO-i_US.indd	73		2008/02/07	10:56:08