Sanyo XMHX1252, XMHX1852, CHDZR09053 Remove the Brackets Used for Transport, Routing the Tubing

4-3. Remove the Brackets Used for Transport

● After installing the unit, remove the 2 transport brackets from the front and rear (4 brackets total). (Fig. 4-5)

4-4. Routing the Tubing

Remove the 2 screws (8 screws total)

Remove the 2 transport brackets from the front and rear (4 brackets total)

Fig. 4-5

●The tubing can be routed out either from the front or from the bottom. (Fig. 4-6)

●The connecting valve is contained inside the unit. Therefore, remove the front panel. (Fig. 4-6)

(1)If the tubing is routed out from the front, use cutting pliers or a similar tool to cut out the tubing outlet slit (part

indicated by ) from the tubing cover. (Figs. 4-6 and 4-7)

Front

Bottom	Remove 11 panel
	screws from front
	panel

Tubing cover
Remove 2 screws	Use cutting pliers or similar
	tool to cut cover out

Fig. 4-6

(2)If the tubing is routed out from the bottom, remove

the slit part ( ).

●Use a drill bit approximately 13/64" dia. to create holes at the 4 slit hole indentations (openings).

●Punch out the slit part ( ).

●Be careful not to damage the base plate.

Indentation (4 locations)

Slit hole

Fig. 4-7

65

W-3WAY_ECO-i_US.indd 65 2008/02/07 10:56:05