Sanyo CHDZR09053, XMHX1252 Display during automatic address setting, LED 2, Blink alternately

Display during automatic address setting

●On outdoor main unit PCB

LED 2 1	* Do not short-circuit the automatic address setting pin (CN100) again while automatic address set-
	ting is in progress. Doing so will cancel the setting operation and will cause LEDs 1 and 2 to turn
Blink alternately	OFF.

*When automatic address setting has been successfully completed, both LEDs 1 and 2 turn OFF.

*LED 1 is D72. LED 2 is D75.

*If automatic address setting is not completed successfully, refer to the table below and correct the problem. Then perform automatic address setting again.

●Display details of LEDs 1 and 2 on the outdoor unit control PCB

(: ON : Blinking : OFF)

LED 1	LED 2	Display meaning
		After the power is turned ON (and automatic address setting is not in progress), no communication with the indoor
		units in that system is possible.
		After the power is turned ON (and automatic address setting is not in progress), 1 or more indoor units are
		confirmed in that system; however, the number of indoor units does not match the number that was set.
Alternating		Automatic address setting is in progress.
		Automatic address setting completed.
		At time of automatic address setting, the number of indoor units did not match the number that was set.
Simultaneous		“ ” (when indoor units are operating) indication appears on the display.
Alternating		Refer to “Table of Self-Diagnostic Functions and Description of Alarm Displays.”

Note: “ ” indicates that the solenoid is fused or that there is a CT detection current failure (current is detected when the compressor is OFF).

●Remote controller display

is blinking

92

W-3WAY_ECO-i_US.indd 92 2008/02/07 10:56:14