Sanyo CHDZR09053 Fixture Double nut Field supply, Approx 63/64 Ceiling Surface Washer Nut

(5)Before suspending the indoor unit, remove the 2 or 3 screws on the latch of the air-intake grilles, open the grilles, and remove them by pushing the claws of the hinges as shown in Fig. 3-117. Then remove both side panels sliding them along the unit toward the front after removing the 2 attachment screws. (Fig. 3-118)

(6)Carry out the preparation for suspending the indoor unit. The suspension method varies depending on whether there is a suspended ceiling or not. (Figs. 3-119 and 3-120)

(7)Suspend the indoor unit as follows:

a)Mount 1 washer and 2 hexagonal nuts on each suspension bolt as shown in Fig. 3-121.

b)Lift the indoor unit, and place it on the washers through the notches, in order to fix it in place. (Fig. 3-122)

c)Tighten the 2 hexagonal nuts on each suspension bolt to suspend the indoor unit as shown in Fig. 3-123.

NOTE

The ceiling surface is not always level. Please confirm that the indoor unit is evenly suspended. For the installation to be correct, leave a clearance of about 3/8" between the ceiling panel and the ceiling surface and fill the gap with an appropriate insulation or filler material.

(8)If the tubing and wiring are to go towards the rear of the unit, make holes in the wall. (Fig. 3-124)

(9)Measure the thickness of the wall from the inside to the outside and cut PVC pipe at a slight angle to fit. Insert the PVC pipe in the wall.

(Fig. 3-125)

Slide toward front side

Side panel

Fig. 3-118

	Suspension bolt
	(field supply)
Unit	Ceiling surface
	Washer (supplied)

Fixture	Double nut
	(field supply)
Fig. 3-119
	Suspension bolt
	(field supply)
	Washer (field supply)
Unit	T
	Washer (supplied)
	Double nut
	(field supply)

Fig. 3-120

Approx.	63/64"
Ceiling
surface
Washer	Nut
(supplied)
	(field supply)

Suspension bolt

Fig. 3-121

Fig. 3-122

NOTE

The hole should be made at a slight downward slant to the outside.

Indoor	Outdoor
side	side

Fig. 3-124

Fig. 3-123

PVC pipe (locally purchased)

INSIDE	Wall	OUTSIDE
		PVC pipe
		Slight
		angle

Cut at slight angle

Fig. 3-125

57

W-3WAY_ECO-i_US.indd 57 2008/02/07 10:56:01