Transition Networks CPSMC0810-100, CPSMC0800-100 manual chassis, CPSMC08xx-100 PointSystem Chassis

CPSMC08xx-100 PointSystem™ Chassis

To install the CPSMC08xx-100 chassis into a standard 19-inch rack:

1.Determine the preferred alignment of the chassis in the rack.

NOTE: Installation bracket mounting screws are provided. Rack mount screws and clip nuts are NOT provided.

2.Locate six (6) installation bracket mounting screws (provided) for each chassis to be installed.

WARNING: Mount the chassis evenly and securely onto the rack. Failure to observe this warning could allow the chassis to fall, resulting in equipment damage and/or possible injury to personnel.

3.Align the universal mounting bracket in the selected position against the side of the chassis so that the chassis installation holes are visible through the universal bracket installation holes.

4.Using a Phillips screwdriver, install the three (3) screws through the mounting bracket into the installation holes on side of the chassis.

CPSMC-0800

8-Slot Chassis

5.Repeat steps 3 and 4 for the second mounting bracket.

6.Locate four (4) screws (not provided) and optional clip-nuts (not provided) for each chassis to be installed.

7.Carefully align the chassis at a secure and level position between the 19-inch site rack mounting rails.

8.Install two (2) screws through the right bracket into the right mounting rail and two (2) screws through the left bracket into the left mounting rail, using the clip nuts to secure, if necessary.

chassis

24 hour Technical Support: 1-800-260-1312-- International: 00-1-952-941-7600 17