TRENDnet BRF114 manual Connect WAN Cable, Power Up, Check the LEDs

Installation

3. Connect WAN Cable

Connect the DSL or Cable modem to the WAN port on the TW100-BRF114. Use the ca- ble supplied with your DSL/Cable modem. If no cable was supplied, use a standard cable.

4. Power Up

•Power on the Cable or DSL modem.

•Connect the supplied power adapter to the TW100-BRF114 and power up.

Use only the power adapter provided. Using a different one may cause hardware damage

5. Check the LEDs

•The Power LED should be ON.

•The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

•For each LAN (PC) connection, the LAN Link/Act LED should be ON (provided the PC is also ON.)

•The WAN LED should be ON.

For more information, refer to Front-mounted LEDs in Chapter 1.

7