TRENDnet BRF114 Rear Panel, Reset Button, WAN port, 10/100BaseT, LAN connections, Power port

Introduction

Rear Panel

	Figure 3: Rear Panel
Reset Button	This button has two (2) functions:
	• Reboot. When pressed and released, the TW100-BRF114 will
	reboot (restart).
	• Clear All Data. This button can also be used to clear ALL data
	and restore ALL settings to the factory default values.
	To Clear All Data and restore the factory default values:
	1. Power Off.
	2. Hold the Reset Button down while you Power On.
	3. Keep holding the Reset Button down for five (5) seconds, until
	the Red Status LED has flashed TWICE.
	4. Release the Reset Button. The TW100-BRF114 is now using the
	factory default values.
WAN port	Connect the DSL or Cable Modem here. If your modem came with a
(10/100BaseT)	cable, use the supplied cable. Otherwise, use a standard LAN cable.
10/100BaseT	Use standard LAN cables (RJ45 connectors) to connect your PCs to
LAN connections	these ports.
	Note:
	Any LAN port on the TW100-BRF114 will automatically function as
	an "Uplink" port when required. Just connect any port to a normal
	port on the other hub, using a standard LAN cable.
Power port	Connect the supplied power adapter here.

5