GB
4. Advanced Operation
4.1 Channel Search
There are 3 different methods of channel search: Auto Search, Manual Search, and Advanced Search. In general, Auto Search is used most frequently.
1Press the Menu button on the remote control. The Main Menu screen will appear.
2Use the CH Up/Down buttons on the remote control to select the Installation menu, and then press the OK button.
4.1.1 Auto Search
Auto Search allows you to search channels by using all the TP information. You can search many channels with ease since all you have to do.
We have already discussed using Auto Search. For details on Auto Search, please refer to [3.1.3 Channel Setup].
4.1.2 Manual Search
Manual Search allows you to search channels by using just one piece of the specified TP information. Use this method to search the specific channels you want. However, since you will be using just one piece of TP information, it is important that the information you have is correct.
You can perform a Manual Search with TP information only (Frequency/Symbol Rate/Constellation).
1In the Installation screen, use the CH Up/Down buttons to select "Manual Search", and then press the OK button.
2Use the CH Up/Down buttons to move between settings and use the Left/Right buttons to change the value. The available settings are as follows:
zFrequency: Set the Frequency of the TP.
zSymbol Rate: Set the Symbol Rate of the TP.
zConstellation : Set the Constellation of the TP.
zSearch Mode: Select the search mode.(All/FTA/Scramble)
zNetwork Search : Search the channels of all identified TPs. You can search many channels with just one piece of TP information.
3Press the OK button. The following Channel Searching screen will appear and channels will be searched. The searched TV and radio channels will be displayed on the screen.
4When the channel search is finished, the following screen will appear. To quit Manual Search, press the Exit button.
