Tripp Lite B064-032-02-IPG Supported Browsers, Components, Front View, No.. Component Description

Introduction (continued)

Supported Browsers

Supported browsers for users that remotely log into the B064-Series KVM Switches include:

Components

Front View

Browser	Version
Internet Explorer*	6 and higher
Firefox	1.5 and higher
Mozilla	1.7 and higher
Safari	2.0 and higher
Opera	9.0 and higher
Netscape	8.1 and higher

* Internet Explorer 64-bit is not supported, only 32-bit.

No.. Component		Description
	Power LED	Illuminates when the KVM switch is powered on
	Port LEDs	Port LEDs will illuminate in colors corresponding to the status of the port:
		Green – Illuminate green when the corresponding port is connected and powered-on
		Red – Illuminate red when the corresponding port is selected as having the KVM’s focus, but is either not
		connected to a computer/server or is connected to a computer/server that is not powered-on
		Orange – Illuminate orange when the corresponding port is connected, powered-on and selected as having the
		KVM’s focus
		Note: The Port LEDs are steady under normal conditions, but will flash at half second intervals when the
		corresponding port is being accessed under Auto Scan Mode or Skip Mode.
	LAN LEDs	The Primary (Link 1) and Secondary (Link 2) LAN LEDs will illuminate in colors corresponding to the
		network transfer rate:
		Red – Illuminate red at speeds of 10 Mbps
		Orange – Illuminate orange at speeds of 100 Mbps
		Green – Illuminate green at speeds of 1000 Mbps
	USB Ports	Note: Only computers connected to the KVM by a B055-001-USB-V2 can access the KVMs Virtual Media
		functionality. Additional USB ports support external keyboard and mouse, as well as virtual media functionality.
	Reset Switch	Note: This recessed switch must be pushed with a thin object, such as the end of a paper clip or a ballpoint pen.
		•	Pressing and releasing the Reset Button when the KVM switch is running performs a system reset.
		•	Pressing and holding the Reset Button in for more than three seconds when the KVM switch is running resets
			the switch configuration to the factory default settings. Note: This does not clear User Account information.
		•	Pressing and holding the Reset Button in while powering on the switch will restore the KVM switch to its
			original firmware in the event of a firmware upgrade failure. Note: This operation should only be performed
			in the event of a firmware upgrade failure that results in the device becoming inoperable.

Port Switching Buttons • Press the Port Down button to switch from the current port to the previous port on the installation.

•Press the Port Up button to switch from the current port to the next port on the installation.

Note: The figure shows the front panel of a B064-032-04-IPG. The B064-032-02-IPG, B064-016-02-IPG and B064-016-04-IPG contain all the same front-panel features as the B064-032-04-IPG, except the B064-016-04-IPG and B064-016-02-IPG come with 16 ports instead of 32.

5