
Introduction
This manual describes how to set up and install your
Each adapter uses
921.6kbps. The adapters are powered over their USB connection
Note: These products comply fully with USB Specification version 2.0. They will also operate over slower USB 1.1 connections at a slightly reduced performance level.
System requirements
Installing the USB-to-Serial Adapter
Caution!
Be sure to allow the installation process to finish without interruption
This section explains how to install the
The
Installing under Windows XP
Follow these steps to install the adapter under Windows XP.
1.Turn the power to your computer ON. This is the system to which the device is to be connected.
2.Plug the wide flat end of the USB cable into the downstream connector. This is the connector located on the back of the computer or USB hub.
3.Plug the square end of the USB cable into the
Figure 1 - The Found New Hardware Wizard launches automatically when you first plug in the USB-to-Serial adapter.
3