Trixter X-Bike manual Preventative Maintenance, Daily, Weekly

Preventative Maintenance

Refer to the appropriate Parts Removal and Replacement section on PAGES 19-28 for all disassembly and assembly instructions. If you experience any problems, contact your Matrix Fitness Systems service department (Details found at www.trixter.net).

CHECKLIST OF ROUTINE MAINTENANCE REQUIREMENTS

Daily

1.Wipe Down the X -Bike™ Indoor Cycle

2.Inspect for loose components and tighten where necessary

Weekly

1.Inspect the Wear Pads for excessive wear or dryness

2.Lubricate the Flywheel

3.Lubricate the Drive Chain

4.Clean the X-Bars™ System and X-Bike™ Indoor Cycle

Monthly

1.Inspect the Chain Tensioning

2.Inspect the X-Bars™ System damper performance

3.Inspect the X-Bars™ System ‘Return to Zero’ Performance

4.Inspect the rigidity of the X-Bars™ System to check for looseness in the mechanism.

5.Inspect the Centre Slider for wear

6.Inspect the Damper slider for wear

7.Inspect the seat and handlebars post adjustment for secure height adjustment tightening

Daily

1.Wipe down the X-Bike after each use to remove sweat and moisture. Use soap and water, or a diluted non-abrasive domestic cleaner solution. Rinse to remove detergent residue and then dry off.

2.If the bikes are used frequently in group exercise sessions, inspect for loose components such as pedals or cranks prior to commencing the next class. Tighten up any loose parts.

Weekly

1.Inspect the resistance wear pads for excessive wear or dryness. If necessary lubricate the pads with GT-85 or another PTFE based lubricant. As the pads wear with use, it will be necessary to adjust the resistance cable to compensate. The resistance cable can be adjusted as follows;

o Turn the minor adjuster wheel on the Grip-shift™ fully clockwise so that there will be sufficient cable in the minor adjustment block for future checks.

o Using a 6mm hex key, loosen the bolt at the bottom of the V-Brake to release the cable for adjustment.

12