Turbo Chef Technologies Tornado 2 owner manual Apply Oven Guard and Clean Oven Exterior

26 m a i n ten a n ce and troubleshooting

Step 10: Apply Oven Guard and Clean Oven Exterior

oSpray Oven Guard on towel. Wipe sides of cook

cavity and inside of door.

ox do not spray Oven Guard directly into cook cavity or wipe on nozzle plates/bottom element.

oWipe the oven exterior with a clean, damp towel.

oOven is ready to turn on.

t i ps for prolonging oven life DO:

oEnsure the oven is cleaned daily.

oUse only TurboChef Oven Cleaner.

oRemove items from the oven as soon as they are cooked.

oUse only microwave-safe TurboChef-approved cooking accessories in the oven.

oReview cooking instructions to ensure oven settings are correct for corresponding products.

oCall Customer Service (800.90TURBO or +1 214-379-6000) or your Authorized Distributor immediately if wave guide covers are broken.

oKeep this manual for future reference.

DO NOT:

ox Lift the oven by its handle.

ox Slam or mishandle the oven door.

ox Place foil or metal objects of any kind in the oven. ox Operate the oven without food in the cook

cavity.

ox Frequently open and close the door to check the product.

ox Cook items wrapped in plastic or any type of cling film.

ox Put products in the oven until ready to cook. ox Use cleaning agents that are not approved for

the oven.

ox Allow any cleaning solution or water to remain on the cook cavity floor after cleaning or at any other time.

ox Place excessive weight on top of the oven.

troubleshooting

In order to save time and money, please perform the following steps prior to calling for warranty service. Reference Table 1 on page 27.

1.Press the back key until the oven screen reads “Cooling Down” or “Oven Off.”

2.Record the serial number (near the top of the screen).

3.Simultaneously press the “4” and “6” keys to view the oven faults.

4.Record the cook count (second line on the screen) and any faults (F1 to F6) that have occurred.

5.Press the enter key, and then the “Self-Test” soft key to initiate an oven self test.

6.Once all subsystems are tested, record which ones - if any - display a “Fail” message.

7.Press the back key until the oven screen reads “Cooling Down” or “Oven Off.”

8.Press the bottom-right soft key to turn on the oven. Allow the oven to warm up to its set temperature.

Upon completing the above steps, please have the information recorded ready when calling Customer Service at 800.90turbo/+1 214-379-6000 or when calling your Authorized Distributor.