Turbo Chef Technologies Tornado 2 owner manual Oven Off

14 o per a t i n g the Tornado Oven

	TRNADO_R 101906		OVEN OFF		PLEASE WAIT
			S/N NGC-XXXXX		WARMING UP
	NGCD-XXXXX
	MENU LOADING...				CC 74OF IR 113OF
			AC VOLTS 240
			OVEN
			ON
figure 11: Initialization Screen		figure 12: Off Screen		figure 13: Warming Up Screen

Po wer i n g Up The Oven

Initial Power-Up

When power is initially applied, the “Initialization” Screen will display the firmware version and the oven’s serial number for five (5) seconds (Figure

11)before advancing to the off screen. The off screen displays “Oven Off” in large text (Figure 12).

Press the “Oven On” soft key — displayed on the lower right of the oven off screen — to turn the oven on and begin warmup.

note: After one (1) hour in the off mode, the display goes to minimum intensity to prevent burn-in. Press any key to re-illuminate.

Power-Up

1.If the display is dim, press any key to re-illuminate. The off screen will be displayed (Figure 12).

Note: The oven off screen displays “Cooling Down” if the cook cavity temperature is in excess of 150ºF (65ºC). Once the cook cavity has cooled to below 150ºF (65ºC), the off screen will no longer display “Cooling Down”.

Note: For U.S. models, the off screen displays the operating voltage.

2.Press the “Oven On” soft key to turn the oven on and begin warmup.

3.The warming up screen will display “Warming Up,” the cook cavity temperature (CC), and the IR Temperature (IR) (Figure 13).

4.When the cook cavity temperature is within 7ºF (5ºC) of the pre-defined set temperature, the oven will display “Ready to Cook” and an alarm will sound.

The Display will immediately advance to the idle screen, from which the user can select a food group.

Voltage Sensing

The oven is factory configured for 240 VAC. Once plugged in, the oven will determine if the incoming voltage differs from the current setting. If the oven senses a 208 voltage supply, you will be asked to change the voltage selection by selecting the indicated voltage (Figure 14).

NOTE: The oven will not ask to be reconfigured unless it detects the voltage supply has changed.

NOTE: Voltage sensing applies to U.S. oven models only.