3.4.1 Hammer Configuration

This section allows you to fine tune the hammer configuration.

HT-LDT Frequency

The port’s transmission frequency.

Options: 1000MHz / 800MHz / 600MHz / 400MHz / 200MHz

Node Interleave

Interleave memory blocks across nodes. Auto will set this enabled when possible. Options: Disabled / Auto

DRAM Bank Interleave

Interleave memory blocks across the DRM chip selects. Auto will set this enabled when possible.

Options: Disabled / Auto

Set FID to MaxFID

Enable this option to set the FID to MaxFID on fused, non-server parts. It also sets the VID to 50mV less than the MaxFID. Disable this option to leave the FID alone. For unfused parts or server parts, enabled will do nothing.

Options: Auto / Disabled

Online Spare

Enable the DRAM controller to designate a DIMM bank as a spare for logical swap during runtime.

Options: Disabled / Enabled

40

http://www.tyan.com

Page 40
Image 40
Tyan Computer S2912 Hammer Configuration, HT-LDT Frequency, Node Interleave, Dram Bank Interleave, Set FID to MaxFID