BI2015 — Ice Maker

 

 

5 Adjust Door

Checking Door Alignment

The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation.

IMPORTANT

Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 26).

1/8"

Figure 26

1.Compare the top edge of the door to the top edge of the cabinet.

2.If the door edge is 1/8" below and parallel to the top of the cabinet, go on to 6 Prepare Plumbing. If it is not, note whether the side opposite the hinge needs to be moved UP or DOWN, and use the following procedure.

Note: If door is adjusted correctly, but panel is not square with the adjacent cabinets, slight adjustments can be

Slotted

MountingNotch

Holes

Raise

 

Lower

 

Outside

 

Outside

Door Edge

 

Door Edge

Figure 28

3.See Figure 28. If the top far edge of the door needs to move UP, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move DOWN, move the hinge plate toward the inside of the door and retighten screws.

4.Mount the door to recheck alignment and repeat Steps 2 and 3 if further adjustment is necessary.

5.When top edge of door is parallel to top edge of cabinet, remove the door and ensure the two screws are secure.

6.Remove the door closers from the bottom hinge, clean thoroughly and lubricate the mating surfaces with petroleum jelly.

made by drilling the holes in the vinyl coated steel panel slightly oversized. See Figure 21 on Page 10.

Adjusting Door Alignment

1. Remove top hinge screw

 

pin (7/64" Allen wrench or

 

Phillips screwdriver,

 

depending on your unit’s

 

construction, see Figure

 

27). Remove door by

 

tilting forward and lifting

 

off bottom hinge pin.

 

2. With door upside-down,

Figure 27

loosen but do not remove

 

the two screws on the door’s bottom hinge plate.

7.Reinstall the closers, lining up the bosses with holes in hinge and hinge plate (see Figure 29).

8.Mount the door, install top hinge pivot pin and go on to 6 Prepare Plumbing.

Door

Closer

Inserts

Boss

Figure 29

www.U-LineService.com

12

02/2005