U-Line BI2015 CAUTION, CAUTION, Installation Instructions

™	BI2015 — Ice Maker

4.Drill hole for upper door hinge (top of panel) (see Figure 16, Top View).

0.177" diameter

(#16 drill) x 11/16" deep

5.Drill hole for lower door hinge (see Figure 16, Bottom View).

5/16" diameter x 1/4" deep

CAUTION

1/8"

13/16"

1-17/32"

7/16"

5/16" Dia.

x 1/2" Deep

13/32"	1/8"	1/8"

1/32" R

1/8" R

13/16"

3/4"

It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed.

Installation Instructions

Removing Existing Door

1.	Remove top hinge screw pin (7/64" hex key or Phillips
	screwdriver, depending on your unit’s construction).
	Remove the door by tilting forward and lifting off the
	bottom hinge pin.
2.	Pull door gasket out of the groove (top edge of door

Back View

Side View

Figure 16

Route notch in top corner of overlay panel as shown (see Top and Side Views). Top of notch is entire depth of panel, front to back.

Width: 13/16"

Depth: 1/8"

Route notch in backside of top corner of overlay panel (see Back and Side Views).

Width: 13/16"

Depth: 1/8"

Height: 1-17/32" from top edge of panel (less 1/8" for depth of notch on top of panel)

Radius of corner notch: 1/8" (see Back View)

3.Drill holes for pivot plate mounts (see Figure 16, Back View).

5/16" diameter x 1/2" deep, from the routed surface

only). Start in the middle and pull outward, moving

toward the edge (see Figure 17). This may take some

force.

New Handle

Old Handle

Figure 17

Figure 18

3.Remove the three screws located on the back of the handle (see Figure 18).

CAUTION

Be careful not to drill too deep! Drilling holes too deep may destroy your door panel.

02/2005