Figure 14

BI2015 — Ice Maker

 

 

Figure 12

Figure 13

2.Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 13). This may take some force. Do not remove the three screws behind gasket.

3.Remove two outside screws holding door handle. Slightly separate door handle from door (see Figure 14).

4.Pull handle up and off.

5.Remove and discard existing panel and

cardboard spacer.

6.Slide custom door panel insert into 1/4-inch channel in door front.

7.Holding door gasket out

of the way, replace handle on door, making sure it is

seated properly on insert and that screw holes line up.

8.Install two small screws removed in Step 3.

9.Starting at the corners and working inward, push door gasket into place on door.

10.Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door.

Full Overlay Door Panel

Door Panel Preparation

A full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit (P/N U-OL2015B — Black or P/N U-OL2015W — White). Appropriate hardware, Modified Handle, Replacement Hinges and a copy of these instructions will be included in the kit.

1.Cut the overlay to the following dimensions (see Figure 15).

Full Overlay Dimensions:

Width: 14-3/4"

Height: 29-7/8"

The door panel must not weigh more than 20 lbs.

3/4"

13/16"

 

 

 

1/8"

 

1/8"

 

 

Relief Notch

Rear View

29-7/8"

of

for Pivot Plate

Wood Panel

 

 

 

14-3/4"

Figure 15

IMPORTANT

Rear View of wood panel for right-hand hinge shown. Use mirror image for left-hand hinges.

2.Create a relief (Figure 15) for pivot plate by cutting notch in top corner and coinciding back corner of overlay panel. Refer to Figure 16 for exact specifications.

www.U-LineService.com

8

02/2005