BI2015 — Ice Maker | ™ |
|
|
4.Remove the top handle and discard. (This handle will be replaced with the Modified Handle included in the Full Overlay Door Panel Kit.)
5.Remove the two screws located on both sides of the lower handle. Remove the handle.
6.Attach the Modified Handle to the lower handle using the three screws removed in Step 3. Set aside.
7.Slide the existing door panel out of the doorframe.
Attaching the Full Overlay Panel
1.Tap nylon inserts into the top holes drilled in the overlay panel. Use two #6 screws to attach top pivot bracket to the overlay panel (see Figure 19).
Typical Wood
Panel
#6 X 5/8"
Flat Head Screw
Two Required
Top Pivot
Plate
8 mm Plug Insert
Two Required
2.Place and tape the existing door panel on the back of the overlay panel (see Figure 20) and drill holes through both panels according to Figure 21. Remove tape adjoining the panels and enlarge the six holes in the overlay panel using a 0.201" (#7) drill.
3.If a
Back of | Tape | |
Removed | ||
Wood | ||
Door Panel | ||
Panel | ||
|
Side of
Wood PanelBottom of
Wood Panel
5/16" | 3/8" |
Bottom | Both Sides |
Figure 20
Figure 19
Rear View
of
Wood Panel
1"± 1/32" | 1"± 1/32" |
Drill 5/32" x 3/8" Deep for use with #10 x 5/8" Wood Screw and Nylon Spacer – 6 Places
27"± 1/4"
1"± 1/8"
Figure 21
4.Attach the door panel to the overlay panel using #10 x 5/8" wood screws and nylon spacers. The nylon spacers fit between the overlay panel and the door panel as shown in Figure 22. The spacers allow the original door panel to slide back into the
10 | 02/2005 |