BI2015 — Ice Maker

 

 

4.Remove the two door closer inserts from the existing bottom hinge and install as shown on the new bottom hinge (see Figure 8).

Hinge

Screw

Pin

Door

Closer

Inserts

Figure 7

Figure 8

5.Remove existing bottom hinge (3 screws) and remount on opposite side TOP. Remove hinge screw pin.

6.Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.

7.With bottom of door facing up, remove pivot plate (2 screws), flip over, and remount on opposite side of door (see Figure 9). Be sure notch in plate faces center.

Other Site Requirements

Power Supply

The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 14.

Water Supply

The unit requires a 1/4-inch OD water supply line and a shut-off valve. For more information see Page 13.

Environmental Requirements

The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (40°C). High ambient temperature ranges and warmer water supply will cause reduced ice production. Black and White units may be installed outdoors in a covered area. Stainless Steel BI2015 units are deemed suitable for outdoor use by UL. The unit must not be located near heat-generating equipment or in direct sunlight.

Figure 9

8.Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin (see Figure 10).

9.Tilt top of door into position in top hinge and install top hinge screw pin.

10.Install plastic screw plugs removed in Step 2 in old hinge holes (3 each, top and bottom).

Figure 10

www.U-LineService.com

6

02/2005