BI2015 — Ice Maker

 

 

Side-By-Side Installation

Instructions

For a complete refreshment center, install your BI2015 Ice Maker beside a U-Line Refrigerator, Combo, or Wine Captain Model (see Figure 11 for typical cut-out). Note that each Side-By-Side Installation will be different.

Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide.

For example:

Placing a BI2015 Ice Maker next to a 2015 series unit would require a cut-out width of:

15-3/16" + 15-3/16" = 30-3/8"

Placing a BI2015 Ice Maker next to a 2075 series unit would require a cut-out width of:

15-3/16" + 24-3/16" = 39-3/8"

No trim kit is required. However, 1/4-inch space needs to be maintained between the units to ensure unobstructed door swing.

Units must operate from separate, properly grounded electrical receptacles placed according to each unit’s Electrical Specifications.

Typical Side-By-Side Cut-Out

23-11/16"

34-1/4"

to 35-1/8"

 

7"

1/4" Space

 

Between Appliances

1"

Figure 11

4 Prepare and Install Door Panel

(Black and White Units Only)

Two types of custom door panels can be installed on your Black or White unit to harmonize with or accent the surrounding décor: a Custom 1/4" Insert or a Full Overlay. If no custom door panel is used, go on to 5 Adjust Door.

Custom 1/4'' Door Panel Insert

Door Panel Preparation

A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides.

IMPORTANT

Raised panels will reduce the door’s 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 5).

Cut the panel insert to the following dimensions.

Custom 1/4" Dimensions:

Width: 14-1/32"

Height: 28-5/32"

The door panel must not weigh more than 20 lbs.

Door Panel Installation

Install the insert as follows:

CAUTION

Use care when handling the insert. Insert edges may be sharp.

1.Remove top hinge screw pin (7/64" Allen wrench or Phillips screwdriver, depending on your unit’s construction, see Figure 12). Remove door by tilting forward and lifting off bottom hinge pin.

02/2005

7

www.U-LineService.com