™ | BI2015 — Ice Maker |
|
|
Typical | Door Panel |
Wood Panel |
|
Top
Pivot Plate
#10 x 5/8"
Round Head Screw
Six Required
Plastic Spacer
Six Required
Figure 22
5.Remove the existing bottom pivot plate and replace with the Full Overlay pivot plate (see Figure 23).
Existing |
|
Door | Wood Panel Bottom Pivot Plate |
| (5/8" Longer Than |
Existing Bottom Pivot Plate | Existing Bottom Pivot Plate, |
(Remove and Discard) | Flush Side Facing Out) |
| |
| Two Places |
Figure 23
IMPORTANT
Door panel and overlay panel must be aligned properly or the door will not operate correctly.
Assembling the Door
1.Install the assembled panel by sliding the original door panel back into the doorframe.
2.Replace the
3.Starting at the corners and working toward the center, push the door gasket back into place.
Installing the Door
1.Remove the existing hinges from the unit, saving the door closure assembly.
2.Install the new Replacement Top Hinge onto the unit (see Figure 24).
Pivot Post
Wood Panel Top Hinge Plate
(5/8" Longer than Existing Top Hinge Plate)
Flat Head Screw
Three Places
Top Pivot Plate
Door Panel
Figure 24
3.Install the pivot post into the new Replacement Bottom Hinge (using the 7/64" hex key or Phillips screwdriver) and install the hinge onto the unit.
4.Replace the door closure assembly onto the bottom pivot post (see Figure 25). Be sure that bosses on closers align with holes in hinge and hinge plate.
| Existing |
| Door |
Door Closure Top | Boss |
Door Closure Bottom |
|
| |
Boss | Three Places |
| Wood Panel Bottom Hinge Plate |
Pivot Post | (5/8" Longer than Existing Bottom Hinge Plate) |
Figure 25
IMPORTANT
Pivot posts must be cleaned. Closers must also be clean and greased to ensure proper operation.
5.Place the modified door onto the pivot post.
6.Position door and install the pivot post into the top hinge (using the 7/64" hex key or Phillips screwdriver).
7.Adjust door as needed for proper closure. Go on to 5 Adjust Door.
02/2005 | 11 |