™BI2015 — Ice Maker

9

Install the Unit

 

10

Start-Up for the First Time

 

 

 

 

 

Installation of the BI2015

1.Open the water supply valve in the main water source.

2.Make sure the ON/OFF switch is in the OFF position (see Figure 36).

3.Plug in the power cord.

4.Gently push the unit into position. Be careful not to kink the water supply line or entangle the electrical cord.

5.Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the countertop.

Installation Troubleshooting

Q: Problem

Water is leaking under the unit.

A: Solution

A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly.

Q: Problem

The door remains open unless it is pushed closed.

A: Solution

The hinges should be self-closing when the door is open approximately 8". If this is not the case, make sure the closers (at the bottom of the hinge pin) are clean, greased and installed correctly. Also, re-check leveling from front to back of the unit and readjust if necessary. Make sure that pivot plate is installed correctly.

Q: Problem

The custom overlay door was designed to align with the rest of the cabinet doors, but the unit has crept forward.

A: Solution

Make sure that the electrical cord and water supply line are not obstructing the installation.

Initial Start-Up

Once installation and leveling is complete, the unit is ready for initial start-up and operation. The ON/OFF switch is located in the front grille (see Figure 36).

Temperature

Control Knob

 

 

OFF

 

 

ON

 

4

 

3

5

 

2

6

OFF

 

 

ON

1

7

 

WARMER

COLDER

 

ON/OFF

Switch

Figure 36

1.Put the ON/OFF switch in the ON position, and set the Temperature Control Knob at 4.

2.As soon as the ice maker mold reaches the proper temperature, the ice maker mechanism will fill the mold with water.

Note: The first cubes may be

small because of air in the Figure 37 water line. Subsequent cubes

will be standard size.

3.The ice maker will continue to produce until the bin is full. You may interrupt production by raising the bin arm into an upright and locked position (see Figure 37). While the bin arm is locked, the unit will maintain temperature for ice storage.

IMPORTANT

It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first twenty-four (24) hours of operation.

About Settings

No adjustments should be necessary at this time. For information about Adjusting the Temperature Control and Adjusting Ice Cube Size, see the User Manual.

02/2005

15

www.U-LineService.com