Ultra electronic Turbo MS Important Cleaning Procedures P, Thermal Printhead Cleaning

Models: Turbo M Turbo MS Turbo

1 37
Download 37 pages 17.55 Kb
Page 29
Image 29

Ultra Electronics Card Systems

Quick Start Guide

Important Cleaning

Procedures P

It is very important that the MagiCard Printer be cleaned at regular intervals in accordance with these instructions. Cleaning Cards and a Cleaning Pen are included with every printer shipped.

Thermal Printhead Cleaning

It is recommended that the Thermal Printhead be cleaned after every roll of dye film, i.e. after every 250 cards printed.

CAUTION Failure to clean the Thermal Printhead after every roll of dye film can result in the build up of residues which cause white lines and streaks in the printed image. The Thermal Printhead is a fragile and expensive item. Care should be taken to avoid damage to the printing surface at its lower edge. The surface of the Thermal Printhead should not be touched with the fingers and under no circumstances should any hard, sharp or abrasive materials be allowed to contact it.

WARNING The recommended cleaning materials are inflammable. Clean the Thermal Printhead in a well-ventilated area and avoid naked flames. Extinguish any cigarettes.

Clean the Thermal Printhead as follows:

1. Switch the printer OFF and isolate from the mains power supply.

WARNING The MagiCard Printer contains potentially lethal voltages.

2.Release the top cover catch on the right-hand side of the printer cover.

3.Lift up the Top Cover to the vertical position, as illustrated.

MAGICARD TURBO Color Printer

Page 29

Page 29
Image 29
Ultra electronic Turbo MS quick start Important Cleaning Procedures P, Thermal Printhead Cleaning