Ultra Electronics Card Systems | Quick Start Guide |
LED Error
Codes Q
The MAGICARD printer has extensive error trapping facilities, to provide the operator or service agent with fault diagnosis information.
READY and ERROR Indicator Flashing
The READY indicator flashing indicates that the printer is receiving and processing a file of image data.
If the ERROR indicator is also illuminated continuously, it indicates that the file of image data is incomplete and that the printer is waiting for the rest. If this need cannot be met (perhaps the PC develops a fault or is reset), then the printer must be rebooted by switching off then on again. Ensure that any files in the Windows Spooler are aborted first.
If the ERROR indicator is also flashing this condition indicates an error in the file downloaded from the PC and the printer must be powered down. To ensure that the error will not repeat after reset, abort the transfer on the PC before resetting the printer by opening and closing the lid.
MEDIA Indicator On
This indicates any of the following:
1.Dye film has run out.
2.The wrong dye film has been fitted with respect to the driver settings.
3.The dye film is jammed.
4.The card hopper is empty.
5.A card is jammed in the mechanism.
MEDIA OUT Indicator Flashing
This indicates that the printer is in hand fed mode and is waiting for the operator to manually insert a card through the front aperture.
READY Indicator Flashing
This indicates that the printhead is too hot. The printer waits for it to cool down before Continuing with the print. If it does not cool down within about 60 seconds, the printer will indicate an ERROR as described below.
ERROR Indicator Flashing
This indicates a system hardware fault. The indicator will flash a number of pulses, pause, and then repeat. The number of flashes indicates the cause of the error. Note the number of flash pulses and contact your service agent.
ERROR and READY Indicators Flashing
This indicates a system hardware fault. The indicators will flash a number of pulses, pause, and then repeat. The number of flashes indicates the cause of the error. Note the number of flash pulses and contact your service agent.
MAGICARD TURBO Color Printer | Page 33 |
