Uniden EXAI 6980 Step 3

10

Step 3 (continued)

Battery use time (per charge)

From fully charged

•Seven hours continuous use.

•Seven days when the handset is in the standby mode.

When the battery charge becomes low

When the voltage of battery pack is very low and

needs to be charged, the phone eliminates functions

to save power. If the phone is not in use,

“Low Battery” flashes and none of the keys

will operate. If the phone is in use, "Low Battery" flashes and the handset

beeps. Complete your conversation as quickly as possible and return the handset to

the base unit for charging.

Notes

•Even when the battery pack is not being used, it will gradually discharge over a long

period. For optimum performance, be sure to return the handset to the base unit after

a telephone call for charging the battery.

•The built-in memory backup holds numbers and names stored in the memory for up

to 2 minutes, while you replace the battery pack.

Cleaning the battery contacts

To maintain a good charge, it is important to clean all battery contacts on the handset

and base unit with a dry cloth or pencil eraser, if necessary, about once a month.

Do not use any liquids or solvents.

EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 10

Contents

Main Introduction Features Table of contents Getting Started Basics Telephone Features Caller ID Features Step 1 Step 2 Step 3 Step 4 About the digital security code Step 1 Checking the package contents Uniden Parts Department Step 2 Setting up the base unit Choose the best location Page Step 2 Choose the dialing mode Page Step 3 Battery use time (per charge) When the battery charge becomes low Cleaning the battery contacts Page Page Page Page Page Receiving calls 1 2 3 Receiving a call from the handset Auto Talk when ringing Any key when ringing Receiving calls Page Page 4 Memory storing 5 6 7 Memory dialing Making calls with memory dialing Dialing from standby 2 1 3 Page Page Memory editing 7 8 9 Display a Programmed Number Page Page Caller ID Features When the telephone rings 1 2 Caller ID Features Viewing the Caller ID Message list 1 2 3 4 Page Page Page Page Page Page Page 1 2 Turning the answering machine on and off 2 : 2 times 4 : 4 times TS :In the TS (toll saver) position, if you Setting the number of rings Setting maximum recording time for incoming messages Page Deleting recorded messages 1 2 AT THE HANDSET AT THE BASE Page Page Page 1 2 3 4 5 6 * Page Page Page Direct wall plate mounting 1 2 8 9 Installing the beltclip To attach the beltclip To remove the beltclip Headset installation Note on power sources Battery replacement and handling RECYCLING NICKEL-CADMIUM BATTERIES Power Failure Ni-Cd Troubleshooting Page 1-800-297-1023 Index 0 - 9 A B C