Uniden EXAI 6980

Making calls

Dialing from standby

1Dial the phone number.

(up to 32 digits.)

Example: Enter 817-858-3300

2Press . “Talk” flashes on the

display. Then the volume setting

appears for a few seconds.

Example: Volume level “High”

3The number is dialed. After about 5

seconds, the call-time display appears.

4To hang up, press or place the

handset on the base. The call-time

will be displayed for about 5 seconds.

Other Operations

To Do this

To improve reception Press .

To adjust the earpiece volume Press or .

To temporarily switch to tone dial (When the Press . The following numbers

the base is set to pulse mode) dialed will be sent as tone dialing.

To enter a pause in the dialing sequence Press .

EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 13

Contents

Main Introduction Features Table of contents Getting Started Basics Telephone Features Caller ID Features Step 1 Step 2 Step 3 Step 4 About the digital security code Step 1 Checking the package contents Uniden Parts Department Step 2 Setting up the base unit Choose the best location Page Step 2 Choose the dialing mode Page Step 3 Battery use time (per charge) When the battery charge becomes low Cleaning the battery contacts Page Page Page Page Page Receiving calls 1 2 3 Receiving a call from the handset Auto Talk when ringing Any key when ringing Receiving calls Page Page 4 Memory storing 5 6 7 Memory dialing Making calls with memory dialing Dialing from standby 2 1 3 Page Page Memory editing 7 8 9 Display a Programmed Number Page Page Caller ID Features When the telephone rings 1 2 Caller ID Features Viewing the Caller ID Message list 1 2 3 4 Page Page Page Page Page Page Page 1 2 Turning the answering machine on and off 2 : 2 times 4 : 4 times TS :In the TS (toll saver) position, if you Setting the number of rings Setting maximum recording time for incoming messages Page Deleting recorded messages 1 2 AT THE HANDSET AT THE BASE Page Page Page 1 2 3 4 5 6 * Page Page Page Direct wall plate mounting 1 2 8 9 Installing the beltclip To attach the beltclip To remove the beltclip Headset installation Note on power sources Battery replacement and handling RECYCLING NICKEL-CADMIUM BATTERIES Power Failure Ni-Cd Troubleshooting Page 1-800-297-1023 Index 0 - 9 A B C