Uniden EXAI 6980

Step 2 (continued)

Connect the base unit

If you want to install the base unit on the wall, see page 47.

1Connect the telephone line cord to

the TEL LINE jack and to a

telephone outlet.

Note Until the handset battery is

fully charged, you can only

answer incoming calls at the

base unit.

2Connect the AC adapter to the

DC IN 9V jack and to a standard

120VAC wall outlet.

3Set the base unit on a desk or table-

top and place the handset on the

base unit.

Then raise the antenna to a

vertical position.

Contents

Main Introduction Features Table of contents Getting Started Basics Telephone Features Caller ID Features Step 1 Step 2 Step 3 Step 4 About the digital security code Step 1 Checking the package contents Uniden Parts Department Step 2 Setting up the base unit Choose the best location Page Step 2 Choose the dialing mode Page Step 3 Battery use time (per charge) When the battery charge becomes low Cleaning the battery contacts Page Page Page Page Page Receiving calls 1 2 3 Receiving a call from the handset Auto Talk when ringing Any key when ringing Receiving calls Page Page 4 Memory storing 5 6 7 Memory dialing Making calls with memory dialing Dialing from standby 2 1 3 Page Page Memory editing 7 8 9 Display a Programmed Number Page Page Caller ID Features When the telephone rings 1 2 Caller ID Features Viewing the Caller ID Message list 1 2 3 4 Page Page Page Page Page Page Page 1 2 Turning the answering machine on and off 2 : 2 times 4 : 4 times TS :In the TS (toll saver) position, if you Setting the number of rings Setting maximum recording time for incoming messages Page Deleting recorded messages 1 2 AT THE HANDSET AT THE BASE Page Page Page 1 2 3 4 5 6 * Page Page Page Direct wall plate mounting 1 2 8 9 Installing the beltclip To attach the beltclip To remove the beltclip Headset installation Note on power sources Battery replacement and handling RECYCLING NICKEL-CADMIUM BATTERIES Power Failure Ni-Cd Troubleshooting Page 1-800-297-1023 Index 0 - 9 A B C