Uniden EXAI 6980 - page 34

34

Using the answering machine

Setting the clock

The answering machine’s clock starts when the AC adapter cord is plugged in.

1Press until you hear the

long beep.

2First set the day by pressing

or .

When the number appears on the LED

display, press .

The unit announces the day

currently selected.

3Next set the hour by pressing

or . When the correct

numbers appear in the LED display,

press .

4Then set the minute by pressing

or . When the correct

numbers appear in the LED display,

press .

5Lastly, set AM/PM by pressing

or . The LED display

will show A (AM) and P (PM) in turn.

At the correct one, press .

You will hear a long beep.

Then you will hear the new day and time.

Notes •You can hear the current time set by pressing .

•If a call comes in during clock setting, start over after the call.

•In case of power interruption, the clock stops. You must reprogram the

time once power is restored.

•If you begin to set the clock, and you pause for more than two minutes,

the unit returns to standby.

EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 34

Contents

Main Introduction Features Table of contents Getting Started Basics Telephone Features Caller ID Features Step 1 Step 2 Step 3 Step 4 About the digital security code Step 1 Checking the package contents Uniden Parts Department Step 2 Setting up the base unit Choose the best location Page Step 2 Choose the dialing mode Page Step 3 Battery use time (per charge) When the battery charge becomes low Cleaning the battery contacts Page Page Page Page Page Receiving calls 1 2 3 Receiving a call from the handset Auto Talk when ringing Any key when ringing Receiving calls Page Page 4 Memory storing 5 6 7 Memory dialing Making calls with memory dialing Dialing from standby 2 1 3 Page Page Memory editing 7 8 9 Display a Programmed Number Page Page Caller ID Features When the telephone rings 1 2 Caller ID Features Viewing the Caller ID Message list 1 2 3 4 Page Page Page Page Page Page Page 1 2 Turning the answering machine on and off 2 : 2 times 4 : 4 times TS :In the TS (toll saver) position, if you Setting the number of rings Setting maximum recording time for incoming messages Page Deleting recorded messages 1 2 AT THE HANDSET AT THE BASE Page Page Page 1 2 3 4 5 6 * Page Page Page Direct wall plate mounting 1 2 8 9 Installing the beltclip To attach the beltclip To remove the beltclip Headset installation Note on power sources Battery replacement and handling RECYCLING NICKEL-CADMIUM BATTERIES Power Failure Ni-Cd Troubleshooting Page 1-800-297-1023 Index 0 - 9 A B C